Pro 40W 8in Single Row LED Driving Light Bar

The Pro 40W 8in Single Row LED Driving Light Bar is a UAG Services PRO Series light bar built for 4x4, off-road, agricultural and heavy vehicle use. 4 x 10W CREE LEDs deliver 3600 lumens in a Euro beam pattern from a black anodised aluminium housing with a machined heat sink for extended run time.

The mounting bracket slides along the bar and adjusts on a pendulum mount, so it can be positioned and angled without extra hardware. An adjustable slide bracket is included; end brackets and round bar clamps are available separately for different mounting points.

Wiring runs through a Deutsch DT series 2-pin waterproof connector. Runs on 9 to 50V DC. IP69K rated and tested from -40°C to +85°C for continuous outdoor and off-road use.

Part of the UAG Services PRO Series single row light bar range, also available in 20W 4.8in, 60W 11in, 180W 30in and 240W 40in sizes.

Vehicle operators who travel between states and territories must ensure that lamps fitted to their vehicles comply with the requirements in each state and territory. Consult your local road authority about fitment and use of driving lamps.

• 4 x 10W CREE LEDs (40W): PRO Series chips producing around 900lm each, 3600 lumens total.
• Euro Beam Pattern: Precision optical reflector for on-road and off-road use.
• Machined Aluminium Housing: Extruded aluminium with a machined heat sink for heat dissipation.
• Adjustable Slide Mount: Bracket moves transversely and adjusts on a pendulum mount; end bracket and round bar clamp available separately.
• Deutsch DT Connector: Waterproof 2-pin connection.
• IP69K Rated: Highest rated washdown and dust protection.

UAGS Driving Light Warranty - 3-Year Limited Coverage
This product is imported and supplied by UAG Services Pty Ltd. It is covered by a 3-year limited warranty against defects in materials and workmanship under normal use.

This warranty does not cover normal wear and tear, weathering or UV degradation, accidental or impact damage, water ingress caused by damaged seals not reported at delivery, incorrect or unauthorised installation, unauthorised modification, or use outside the product's stated voltage and operating conditions. Installation should be carried out by a qualified auto electrician; damage caused by DIY wiring is not covered.

To make a warranty claim, contact UAG Services Pty Ltd (Gate 2, 7 Royan Place, Bayswater North VIC 3153) at sales@uags.com.au or (03) 8750 0926 with your order reference, a description of the fault and photos of the product. Claims are subject to inspection and approval. Where a defect is confirmed, UAG Services Pty Ltd will repair, replace or refund the product at its discretion. Return shipping costs are handled in accordance with the UAGS Returns Policy unless otherwise required under Australian Consumer Law.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. This warranty is provided in addition to these rights and does not limit or exclude them.