80W 6.7in Round Driving Light

The 80W 6.7in Round Driving Light is a UAG Services driving light built for heavy vehicles, off-road, construction, forestry and mining use. 8 x 10W CREE LEDs deliver 7200 lumens, with a super spot option throwing a 5 degree beam up to 800m, plus Euro and flood options.

The die-cast aluminium housing uses an advanced vertical heat sink design for sustained output, mounted on a stainless steel bracket and wired through a Deutsch connector.

Runs on 9 to 50V DC. IP68 rated, tested from -40°C to +105°C, and vibration and shock tested to 15Grms (24-2000Hz) and 60g respectively, with EN55015 EMC compliance.

Also available as the 120W 8.2in Round for higher output.

Vehicle operators who travel between states and territories must ensure that lamps fitted to their vehicles comply with the requirements in each state and territory. Consult your local road authority about fitment and use of driving lamps.

• 8 x 10W CREE LEDs (80W): 7200 lumens total output, 6000K.
• Super Spot Option: 5 degree super spot beam reaching up to 800m.
• Spot, Euro or Flood: Beam pattern options to suit long-range, general or wide-area use.
• Vertical Heat Sink Design: Advanced heat sink for sustained output.
• Die-Cast Aluminium Housing: Stainless steel mounting bracket, Deutsch connector.
• IP68 Rated, Vibration and Shock Tested: 15Grms (24-2000Hz) vibration, 60g shock, EN55015 EMC compliant.

UAGS Driving Light Warranty - 3-Year Limited Coverage
This product is imported and supplied by UAG Services Pty Ltd. It is covered by a 3-year limited warranty against defects in materials and workmanship under normal use.

This warranty does not cover normal wear and tear, weathering or UV degradation, accidental or impact damage, water ingress caused by damaged seals not reported at delivery, incorrect or unauthorised installation, unauthorised modification, or use outside the product's stated voltage and operating conditions. Installation should be carried out by a qualified auto electrician; damage caused by DIY wiring is not covered.

To make a warranty claim, contact UAG Services Pty Ltd (Gate 2, 7 Royan Place, Bayswater North VIC 3153) at sales@uags.com.au or (03) 8750 0926 with your order reference, a description of the fault and photos of the product. Claims are subject to inspection and approval. Where a defect is confirmed, UAG Services Pty Ltd will repair, replace or refund the product at its discretion. Return shipping costs are handled in accordance with the UAGS Returns Policy unless otherwise required under Australian Consumer Law.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. This warranty is provided in addition to these rights and does not limit or exclude them.